You can easily make a Cooler/Radiator for your HHO Generator by using
stainless steel tubing. Tubing can be bent and shaped as desired, and
placed in front of or behind the radiator or fan- where air can pass
across it. You will need to pump the water from the bubbler, through the
tubing, and then to the cell. This should lower the temperature of the
water by 10 to 15 degrees or more.
Stainless Steel must be used because of the Caustic Electrolytes
we use.
Aluminum and Copper will not last long; both deteriorate fast
(do not use them).
316L stainless is not necessary because electrolysis is not
taking place inside the tubing.
PVC tubing could be used; but would not work as well as SS.
1/4" Stainless Brake
Line Coil
Aircraft quality 304 grade stainless features 20' of
.028" wall tubing that is pressure tested and double annealed for easy
flaring and bending.
Available at Jeg's web site
Aircraft quality 304 grade stainless features 20' of .028" wall tubing
that is pressure tested and double annealed for easy flaring and
bending. Ideal for use as fuel line and many other applications.
3/8 inch
Available at Jeg's web site
Aircraft quality 304 grade stainless features 20' of .028" wall tubing
that is pressure tested and double annealed for easy flaring and
bending. Ideal for use as fuel line and many other applications.
5/16 inch
Available at Jeg's web site
I found this hot water pump after hours of searching for a product that
would be compatible with HHO. This pump can take the heat, but I do not
know for certain if it can take the KOH.
A best selling, economical and well
proven pump, ideal for use in solar hot-water systems
High temperature capability -40C to +120C
Operates on 9 - 14 Volts DC, 6.6 Watts
Very compact, almost silent in operation
Efficient:- Uses under 7 Watts of power
Flow rate from <1 ltr per minute to 6.9 ltrs per min
Brushless for longer maintenance-free life
High Quality Ceramic axis for increased durability
Rated for continuous use.
Can operate from Solar Panel (PhotoVoltaic) power
Centrifugal Impeller, creates 2 meter head of water
Inlet 14.1mm, Outlet 10mm for easy fitting to standard plumbing
Design Life >15000 hrs(over
6.8 yrs @ average 6hrs per day)
Available from sellers web site
Jabsco 12 VDC Pump, 1.6 amp
1 Gallon per minute
3/8 inch Inlet and Outlet barbs
Rated for Continuous operation
Part No.
42510-0000
Available from Sellers web site
Example: (you would use round
bends instead of square)