The Cell has a
winter jacket to cover it; made from pvc and has this new 8 layer space age
stuff as an inner lining to keep it warm. It's used for insulation under
baton roofs. So this will look cool.
The cell has a 22 inch outer case with 3 20 inch inner tubes. It has a
bolt welded either end to the center tube; 1.9 mm thick wall, to take the
heat. The bolts are M16. The whole thing is polished 316L stainless steel;
including the bubbler - the whole lot!
The cell sits on a wall strap that has been made into a bracket; sits on it
a bit like a toilet roll does on its bracket - earthing out at both ends.
Adjusts backwards and forwards to get a good gravity point.
The cap ends were metal spun out of alloy then polished. The slide
over each end to hide the bracket and the bolts and nuts at each end.
Inside tubes are 1.5, 1.75, and 2.0 inches in
diameter; 20 inches long; 0.065 wall thickness
Container is 3 inches in diameter; 22 inches long.
The bubbler was measured and built to
fit the truck. The inlet and outlet gas pipes on the bubbler are all made
out of 316 half inch tube. Then the elbows were individually made into 90
degree bends and then milled to gain a barb for the pipes to grip.
Then welded to the direction of the desired choice.
The water level elbows are the same process. The top and bottom were then
welded up with cut 3 inch circles cut out of 316 plate 1.6mm wall thickness;
as is all the cell. Then a hole made for the view port. The view port is a
welded nut allowing the stainless stopper to fit.
Then was polished on the polishing wheel.
|