|
Magnetic Alignment
How to find the North and South ends of your stainless
steel tubes.
Stainless Steel be very low magnetic, but it still has
some magnetism to it; even non-magnet ss has "some" magnetism. Your tubes need to be magnetically aligned in order for them to
produce at their best. They must all be aligned with their MOST Magnetic
ends facing the same direction. If you do not do this, you won't get much
gas production around a miss-aligned tube. "Joe Cell" technology teaches us
the same thing. I believe the Magnetic Force has an effect on the separation
of the water molecules. It supposedly happens on the "surfaces of the tubes"
as the ions are attracted to their opposite polarities. The amount of
voltage (which is electrical pressure) and the amount of current - the
movement of electrons flowing through the cell (which we are measuring in
Amps) has a direct relation to the amount of HHO gas that is produced. This
is Ohms Law, not rocket science.
To produce the best magnetic field, all of the tubes need to be aligned
exactly the same. Once you accomplish that. Apply your Negative DC voltage to the
"bottom" of the center tube, and Positive to the top of the outside tube. This sets
up a North South alignment of magnetic field. The field will be in the shape
of a figure 8 .... encompassing the entire surface of the tubes. When that alignment
happens, your HHO will move "up and out" not downward. If your
electrical connections are both at the top, the magnetic field encompasses
only the top of the tubes.
Again, if you apply both Positive and Negative at the top of the tubes, even when using Flat
Plates, the magnetic field has a tendency to push the HHO to the sides, or
Down. On the other hand, if you apply the DC at the bottom for all of your
tubes/plates, the magnetic field has a tendency to push your HHO to the
sides or UP. Watch anyone's videos that is using a clear container and pay
attention to where they are applying the DC. You will see exactly what I
mean. My own video that uses the tubes with perforated holes will show you
my point.
Because you are using tubes, you are making both a water capacitor and a
water inductor. A capacitor stores voltage. An inductor can collect voltage,
transfer voltage, and produce a magnetic field. So get your tubes
aligned magnetic N & South.
If you do not align your tubes/plates first, the cell will
not function at its best. When you apply voltage to the tubes, and start
producing electrical current, the induced magnetic field that is produced
will be opposed by any miss-aligned tubes. Oxygen bubbles will be influenced
to hang around instead of heading up and out. It may take several hours of
operation, but eventually the stronger magnetic field will polarize all of
the tubes magnetically the same. Your non-magnetic steel becomes
magnetically aligned on its own. But if you want your cell to work right out
of the gate, magnetically align and assemble the tubes first.
|
